Wastewater secondary treatment solution

Choose AquaSust Professional Wastewater Treatment Experts
Home / All / MBBR NEWS /

What are the feed water quality requirements for MBBR systems?

What are the feed water quality requirements for MBBR systems?

Mar 20,2024
The feed water quality requirements for Moving Bed Biofilm Reactor (MBBR) systems vary depending on the specific application, target effluent quality, and regulatory standards. However, there are general water quality parameters that need to be controlled to ensure optimal performance of the MBBR process. Addressing these parameters can help in maintaining the health and efficiency of the biofilm and the overall system. Here are some of the key feed water quality requirements for MBBR systems:

1. PH Level
The pH of the influent should typically be in the range of 6.5 to 8.5 to provide a conducive environment for microbial activity. Extremes in pH can inhibit biofilm growth and microbial processes.
2. Temperature
Most MBBR systems are designed to operate efficiently within a temperature range of 10°C to 30°C. Microbial activity can decrease at temperatures outside this range, affecting the treatment efficiency.
3. Dissolved Oxygen (DO)
Adequate dissolved oxygen is crucial for aerobic biological processes. A DO concentration of 2 mg/L or higher is generally recommended, although specific requirements may vary based on the load and type of wastewater being treated.
4. Nutrients
Nitrogen and phosphorus are essential nutrients for microbial growth. The optimal ratio of biochemical oxygen demand (BOD):nitrogen:phosphorus (BOD:N:P) is usually considered to be 100:5:1 for balanced microbial growth. Insufficient nutrients can limit biofilm development, while excess can lead to eutrophication in the effluent discharge area.
5. Toxic Substances
Heavy metals, toxic chemicals, and other substances harmful to microbial life should be minimized in the influent. Concentrations of these compounds should be within the tolerance levels of the system's microbial community. Pre-treatment may be required to reduce toxicity.
6. Solids
High levels of suspended solids can clog the media, reducing the efficiency of the biofilm and the aeration system. Pre-treatment steps such as screening and sedimentation can be necessary to reduce solids entering the MBBR system.
7. Oil and Grease
Oil and grease concentrations should be minimized as they can form a film over the media, inhibiting oxygen transfer and microbial access to wastewater nutrients. Pre-treatment like grease traps can be used to lower oil and grease levels.
8. Surfactants
Surfactants can cause foaming and affect the operation of the MBBR system. Reducing surfactant levels in the influent through source control or pre-treatment can be beneficial.
9. Organic Load
The concentration of organic matter, often measured as BOD or chemical oxygen demand (COD), influences the design and operation of the MBBR system. Systems must be sized and operated based on the expected organic load to avoid overloading the biofilm.
Choose AquaSust Professional Wastewater Treatment Experts
Contact Person
Kate Nana
Name:
Kate Nana
Tel:

86-15267462807

Email:
WhatsApp:
https://wa.me/15267462807
Please send your message to us
*Email
Name
Tel
*Title
*Content
Upload
  • Only supports .rar/.zip/.jpg/.png/.gif/.doc/.xls/.pdf, maximum 20MB.
Address